The sensor is made of alloy steel or stainless steel and features a unique side-pressure structure. Its working principle is that the steel wire rope is fixed on the sensor through U-shaped bolts (or pressure blocks + bolts) and slots at both ends. When the steel wire rope is under tension, the force acts on the sensor through the guide wheel. It is applicable to the measurement and control of wire rope tension and is mainly used on lifting equipment such as electric hoists, material hoists and wire rope direct cranes.
download
Description
The sensor is made of alloy steel or stainless steel and features a unique side-pressure structure. Its working principle is that the steel wire rope is fixed on the sensor through U-shaped bolts (or pressure blocks + bolts) and slots at both ends. When the steel wire rope is under tension, the force acts on the sensor through the guide wheel. It is applicable to the measurement and control of wire rope tension and is mainly used on lifting equipment such as electric hoists, material hoists and wire rope direct cranes.
Characteristics：
high reliability, good interchangeability, easy to install, simple operation, easy to maintain
Dimensions （In mm. 1mm=0.03937 inches）
Circuit Diagram ：
Red: ＋input
Blue： -input
White： +output
Yellow： -output
Specification
| Type | Technical parameters |
| Nominal load range | 1～10t |
| Power supply | 10~12 VDC |
| Zero balance | 1.0±% of rated output |
| Analog output | 2.0±0.01mV/V |
| Input resistance（Rlc） | 400±20Ω（ohms） |
| Output resistance（Ro） | 350±5Ω（ohms） |
| Insulation resistance | ≥5000 MΩ（Mege-Ohms） |
| Class precision | 0.05%FS |
| Effect of temperature | 0.02%FS/10℃ |
| Operating temperature | -40～+85℃ |
| Safe Load Limit | 200% FS |
| Safety margin against yielding | 300% FS |
| Safety margin against breakage | 500% FS |
| Material material | High performance alloy steel or (chromium ratio>15% stainless steel) |
| Protection type | IP67/IP68 |
Get In Touch With Us !
partner
partner
